Atec Agilent-E5063A - Manual (Page 3)

3
The specifications in this section apply to measurements made with the Agilent E5063A network analyzer under the following
conditions:
• No averaging applied to data
• Environmental temperature of 23 °C (± 5 °C) with less than 1 °C deviation from the calibration temperature
• Response and isolation calibration performed
Corrected System Performance
System Dynamic Range
Description Specification Typical
System dynamic range at test port 1
(IF Bandwidth = 3 kHz)
100 kHz to 300 kHz 63 dB
300 kHz to 8.5 MHz 68 dB
8.5 to 100 MHz 91 dB
100 MHz to 4.34 GHz 92 dB
4.34 to 8.5 GHz 81 dB
8.5 to 13 GHz 75 dB
13 to 16 GHz 65 dB
16 to 18 GHz 62 dB
(IF Bandwidth = 10 Hz)
100 kHz to 300 kHz 88 dB 92 dB
300 kHz to 8.5 MHz 93 dB 97 dB
8.5 to 100 MHz 116 dB 122 dB
100 MHz to 4.34 GHz 117 dB 122 dB
4.34 to 8.5 GHz 106 dB 112 dB
8.5 to 13 GHz 100 dB 106 dB
13 to 16 GHz 90 dB 100 dB
16 to 18 GHz 87 dB 93 dB
1. The test port dynamic range is calculated as the difference between the test port rms noise floor and the source maximum output power. The effective
dynamic range must take measurement uncertainty and interfering signals into account.