MoTeC ADL EDL - Manual (Page 25)

MoTeC Installation 23
Installation
Mounting
Mounting Dimensions
Refer to the product dimensions in the Appendices.
Attachment
Use washers between the unit and the mounting panel to ensure that the unit
is mounted only at the mounting points (to avoid twisting the case). The ADL
has three threaded mounting posts, while the EDL has four mounting holes.
Do not over tighten the mounting screws (to avoid twisting the case).
Vibration isolation may be desirable if the vehicle vibrates severely.
ADL Orientation
For best contrast, the display should be viewed at approximately 20 degrees
above normal, however the ADL will give good contrast between 0 and 40
degrees. Display reflections should also be considered when determining the
mounting angle.
20°
Lighting
The ADL display has excellent visibility in a very wide range of lighting
conditions, however for night time use a front light module is required.
Connector Access
Mount so that the connector may be easily accessed.