MoTeC ADL EDL - Manual (Page 30)

28 Installation
ADL Setup
Setup for the ADL is done in the ‘Inputs | Communications’ setup screen, on
an unused CAN tab.
Select a communications template that matches the ECU type and ECU set.
In the displayed channel list, check those channels that you wish to receive in
the ADL.
ECU Sensor Calibrations
Metric Calibration of the sensors should be used in the ECU otherwise special
scaling is required in the ADL communications setup.
Telemetry
The ADL can transmit telemetry information via a radio link.
• Note that if RS232 ECU communications is used then the telemetry baud
rate must be the same as the ECU communications baud rate (normally
9600 or 19200 baud)
Wiring
Wiring is dependent on the particular telemetry system, please consult the
wiring details supplied with the telemetry system.
ADL Setup
Set the RS232 communications for Telemetry Only, or ECU and Telemetry.
The telemetry channels should then be configured in the separate Telemetry
Setup screen, found under the ‘Functions’ menu.