MoTeC ADL EDL - Manual (Page 64)

62 Appendices
Appendix H: CAN Wiring - Single Device
When a single device is connected to the CAN bus then the wiring scheme
shown below may be used to provide a connection point for the MoTeC CAN
cable.
If the wiring length is less than 2m (7ft) then the terminating resistor is
recommended but not essential.
If other devices are connected to the CAN bus a special wiring scheme is
required, see Appendix G: CAN Wiring - Multiple Device.
1
2
3
4
5 71
72
73
74
Black
Red
Green
White
5 Pin Connector ADL
0V
CAN-LO A
CAN-HI A
8V
100R Resistor
* Not essential if the w iring
length is less than 2m (7ft)
75
76
CAN-LO B
CAN-HI B
These wires must be Twisted
Minimum one twist per 50mm (2in)
Note that CAN-LO A is connected to CAN-LO B inside the ADL. Similarly
CAN-HI A is connected to CAN-HI B. The ‘B’ connections are provided to
simplify the wiring.
5 Pin Connector Type:
Deltron 716-0-0501 (Non Latching)
Neutrik NC5FDL1 (Latching)