ALESIS 03D - Manual (Page 183)

Setting a Fade Time
173
03D—Owner’s Manual
Setting a Fade Time
The Fade Time page can be used to specify a common fade time at which fader levels
move to their new positions. This can be used to create cross fades between scenes. The
fade time can be applied to faders individually. Once the Fade Time parameters have
been set, they must be stored to a scene memory before they can be used. When the
scene memory is recalled, its fade time settings are used. When another scene memory
is recalled, the fade time settings of that scene memory are used.
1. Use [SCENE MEMORY] button to locate the Fade Time page shown
below.
2. Select the FADE TIME control.
3. Use the PARAMETER wheel or mouse to set the FADE TIME.
The FADE TIME can be set from 0.0 to 10.0 seconds in 0.1 second steps.
As the only rotary control on the Fade Time page, the FADE TIME control can be
adjusted using the PARAMETER wheel regardless of the cursor position.
4. Use the cursor buttons to select faders and the [ENTER] button to enable
them.
If you are using a mouse, simply click the switches.
5. Store the current mix settings to a scene memory.
The fade time parameters are stored along with other mix settings. When this scene
memory is recalled, enabled faders move to their new positions at the specified fade
time.