ALESIS 03D - Manual (Page 49)

Phase
39
03D—Owner’s Manual
Phase
The Phase function reverses the phase of an input signal by 180 degrees. The phase can
be set for input channels 1 to 24 and the left and right channels of stereo input channel.
Phase reversal can be used to compensate for incorrectly wired balanced cables and
microphones. When a snare drum is miked top and bottom, the channel connected to
the bottom microphone can be phase reversed.
1. Use the [DELAY/
∅
] button to locate the Phase page shown below.
2. Use the [SEL] and [MIXING LAYER] buttons to select a channel. See Mix-
ing Layer on page 31 for more information.
3. Use the [ENTER] button to set the phase of the selected channel.
You can also use the cursor button to select the phase switches. If you are using a mouse,
simply click the phase switches. Phase switches can also be selected using the [SEL] but-
tons.
Normal phase
Phase reversed
The Phase function is not linked when channels are paired, and can be set indepen-
dently for each channel in the stereo pair.