ALESIS 03D - Manual (Page 57)

Adjusting the EQ
47
03D—Owner’s Manual
Adjusting the EQ
1. Use the [SEL] and [MIXING LAYER] buttons to select a channel. See Mix-
ing Layer on page 31 for more information.
2. Use the [EQ LOW], [LO-MID], [HI-MID], or [HIGH] button to access the
EQ page shown below.
3. Use the [EQ LOW], [LO-MID], [HI-MID], and [HIGH] buttons to select the
EQ parameters and the PARAMETER wheel to adjust them.
Repeated pressing of the [EQ LOW], [LO-MID], [HI-MID], and [HIGH] button cycles
through the gain, frequency, and Q parameters of the respective band, allowing quick
and easy EQ adjustments.
You can also use the cursor buttons to select EQ parameters. If you are using a mouse,
position the mouse cursor over a control, press and hold the left mouse button, and
then drag the mouse.
The following table lists the EQ specs.
Bypassing the EQ
To bypass the EQ for the selected channel, simply press the [ENTER] button.
Press again to turn the EQ back on. On the EQ page the [ENTER] button can
be used to bypass the EQ regardless of the cursor position. If you are using a
mouse, simply click the EQ ON switch on the EQ page.
Resetting the EQ Gain Controls
To reset the EQ gain controls for the selected channel, press the EQ [HI-MID] and
[HIGH] buttons together. The frequency and Q controls are not reset.
1. The Low and High gain controls work as filter on/off switches when the HPF and LPF
filters are selected using the Q control.
2. This is the frequency range for sampling rates of 44.1 kHz and 48 kHz. At a sampling
rate of 32 kHz the range is 21 Hz–15.1 kHz (115 steps).
Low Lo-Mid Hi-Mid High
Gain –18.0 dB to +18.0 dB (0.5 dB steps) 1
Frequency
21 Hz–20.1 kHz (1/12 octave steps, 120 steps)
2
Q
HPF, 10.0–0.10
(41 steps),
L.SHELF
10.0–0.10 (41 steps)
LPF, 10.0–0.10
(41 steps),
H.SHELF