ALESIS 03D - Manual (Page 194)

184
Chapter 16—Automix
03D—Owner’s Manual
Selecting Parameters for Recording
You can select parameters for automix recording and rerecording using the OVER-
WRITE switches on the Main page.
1. Use the [AUTOMIX] button to locate the Main page.
2. Use the cursor buttons to select the OVERWRITE switches, and the
[ENTER] button to set them.
If you are using a mouse, simply click the OVERWRITE switches.
Parameters are selected for recording when the corresponding switch in highlighted.
The following table lists the parameters affected by the OVERWRITE switches.
Scene memory recalls, channel, EQ, effects, and dynamics library recalls, scene recall
safe channel settings are recorded regardless of the OVERWRITE switch settings.
The following parameters are not recorded in an automix: surround mode selection,
input attenuators (EQ page), Bus to ST pan and on/off, aux pair pan, and 3+2+1 sur-
round subwoofer trim. To change these parameters in an automix, store the desired set-
ting in a mix scene and use the automix to recall that scene. Input attenuator and aux
pair pan settings can also be stored in a channel program, which can be recalled by the
automix.
Switch Parameters
FADER Normal CH faders, CH AUX sends, & CH Effect sends
CH ON Channel [ON] buttons
EQ EQ
Pan Pan, balance, surround pan