Safety instructions, General safety instructions, Chapter – ALLIED Vision Technologies Oscar F-810 User Manual
Page 17
Safety instructions
FireWire Hardware Installation Guide V8.0.0
17
Safety instructions
This chapter describes safety instructions/cautions valid for all AVT camera fam-
ilies and special safety instructions/cautions depending on the camera family/
model used.
General safety instructions
Note
•
There are no switches or parts inside the camera that
require adjustment. The guarantee becomes void upon
opening the camera casing.
•
If the product is disassembled, reworked or repaired by
other than a recommended service person, AVT or its sup-
pliers will take no responsibility for the subsequent per-
formance or quality of the camera.
•
The camera does not generate dangerous voltages inter-
nally. However, because the IEEE 1394a and 1394b stan-
dard permit cable power distribution at voltages higher
than 36 V, please note that various country-specific
regulations apply.
Note
•
All color models are equipped with an optical filter to
eliminate the influence of infrared light hitting the sen-
sor. Please be advised that, as a side effect, this filter
reduces sensitivity in the visible spectrum. The optical fil-
ter is part of the back focus ring, which is threaded into
the C-Mount.
•
B/w models are delivered with a sensor protection glass
mounted in the back focus ring to ensure maximum sen-
sitivity. In certain applications and depending on the
lighting source and optics, the use of either IR blocking
or IR passing filter may be required to improve the image
quality.