ALLIED Vision Technologies Oscar F-810 - Manual (Page 57)

Camera interfaces
FireWire Hardware Installation Guide V8.0.0
57
Input description of Pike F-505
Pike F-505 has a different input wiring compared to the other Pike models. The
inputs of Pike F-505 are the same as the inputs of Stingray.
Pike F-505 input block diagram
The inputs can be connected directly up to max. +24 V. If you want to use volt-
ages from +24 V...+36 V you have to place an external resistor of 1.5 k
 (1/10
watt) in series with your voltage source.
Figure 24: Pike F-505 input block diagram
Caution

Pike F-505
• Voltages above +24 V (without external resistor) may
damage the camera.
• Voltages above +36 V (with an external resistor of
1.5 k
) may damage the camera.
Parameter Value
U
in
(low) 0 V ... 1.5 V
U
in
(high) 3 V ... 24 V
Current (constant current source
within the camera)
8 mA
Flux voltage of the LED (@ 10 mA) 1.5 V
Table 12: Stingray input parameters
GPIn1
InGND
external internal
GPInX