Guppy input description, Guppy (housing) input block diagram – ALLIED Vision Technologies Oscar F-810 User Manual
Page 71
Advertising
Camera interfaces
FireWire Hardware Installation Guide V8.0.0
71
Guppy input description
Guppy (housing) input block diagram
(For board level see Chapter
Stingray board level camera: I/O pin assignment
The inputs can be connected directly to +5 V. If a higher voltage is used, an
external resistor must be placed in series.
Figure 35: Guppy (housing) input block diagram
Caution
Guppy
Voltages above +36 V may damage the camera.
Max. 50 mA per input.
Used input voltage
External series resistor
5 V
none
12 V
22 k
24 V
56 k
36 V
91 k
Table 16: Guppy: external resistors for voltages higher than 5 V
GPIn1
external internal
GND
Advertising
This manual is related to the following products:
- Oscar F-510 Oscar F-320 Marlin F-201 Marlin F-146 Marlin F-145 Marlin F-080 Marlin F-046 Marlin F-033 Guppy F-503 Guppy F-146 Guppy F-080 Guppy F-046 Guppy F-044 Guppy F-038 Guppy F-036 Guppy F-033 Pike F-1600 Pike F-1100 Pike F-505 Pike F-421 Pike F-210 Pike F-145 Pike F-100 Pike F-032 Stingray F-504 Stingray F-201 Stingray F-146 Stingray F-145 Stingray F-125 Stingray F-080 Stingray F-033 Guppy PRO F-503 Guppy PRO F-201 Guppy PRO F-146 Guppy PRO F-125 Guppy PRO F-095 Guppy PRO F-046 Guppy PRO F-033 Guppy PRO F-032 Guppy PRO F-031