ALLIED Vision Technologies Oscar F-810 - Manual (Page 45)

Camera interfaces
FireWire Hardware Installation Guide V8.0.0
45
Camera I/O connectors (12 pin) order numbers
and cables: Guppy PRO, Stingray, Pike, Marlin,
Oscar
The 12-pin camera I/O connector (Guppy PRO, Stringray, Pike, Marlin, Oscar) is
also designed for industrial use and, in addition to providing access to the
inputs and outputs on the camera, it also provides a serial interface for e.g. the
firmware update.
The connector is available in straight and angled version.
Note

AVT supplies suitable I/O cables of different lengths (up to
10 m) as shown below.
www

For more information on cables and on ordering cables
online (by clicking the article and sending an inquiry) go to:
http://www.alliedvisiontec.com/emea/products/
accessories/firewire-accessories.html
Note

For pinning of the I/O connectors as viewed in pin direction
see:
• Chapter Stingray camera I/O connector pin assignment
on page 47
• Chapter Pike camera I/O connector pin assignment on
page 54
• Chapter Guppy PRO camera I/O connector pin assignment
on page 62
• Chapter Marlin camera I/O connector pin assignment on
page 76
• Chapter Oscar camera I/O connector pin assignment on
page 82