ALLIED Vision Technologies Guppy F-503 - Manual (Page 279)

Configuration of the camera
GUPPY Technical Manual V7.1.0
279
Stored settings
The following table shows the settings stored inside a profile:
The user can specify which user profile will be loaded upon startup of the
camera.
This frees the user software from having to restore camera settings, that dif-
fer from default, after every cold start. This can be especially helpful if third
party software is used which may not give easy access to certain advanced
features or may not provide efficient commands for quick writing of data
blocks into the camera.
Standard registers Standard registers
(Format_7) Advanced registers
Cur_V_Frm_Rate
Cur_V_Mode
Cur_V_Format
ISO_Channel
ISO_Speed
BRIGHTNESS
AUTO_EXPOSURE (Target grey level)
SHARPNESS
WHITE_BALANCE (+ auto on/off)
GAMMA (+ gamma on)
SHUTTER (+ auto on/off)
GAIN
TRIGGER_MODE
TRIGGER_POLARITY
TRIGGER_DELAY
ABS_GAIN IMAGE_POSITION (AOI)
IMAGE_SIZE (AOI)
COLOR_CODING_ID
BYTES_PER_PACKET TIMEBASE
EXTD_SHUTTER
IO_INP_CTRL
IO_OUTP_CTRL
IO_INTENA_DELAY
AUTOSHUTTER_CTRL
AUTOSHUTTER_LO
AUTOSHUTTER_HI
AUTOGAIN_CTRL
AUTOFNC_AOI (+ on/off)
TRIGGER_DELAY
MIRROR_IMAGE
LUT_CTRL (LutNo; ON_OFF is not saved)
Table 130: User profile: stored settings
Note

• A profile save operation automatically disables captur-
ing of images.
• A profile save or restore operation is an uninterruptable
(atomic) operation. The write response (of the asyn-
chronous write cycle) will be sent after completion of
the operation.
• Restoring a profile will not overwrite other settings
than listed above.
• If a restore operation fails or the specified profile does
not exist, all registers will be overwritten with the
hard-coded factory defaults (profile #0).
• Data written to this register is not reflected in the
standard memory channel registers.