ALLIED Vision Technologies Guppy F-503 - Manual (Page 87)

Camera interfaces
GUPPY Technical Manual V7.1.0
87
Output modes
The Polarity setting refers to the input side of the inverting driver.
ID Mode Default
0x00 Off
0x01 Output state follows PinState bit
0x02 Integration enable Output 1
0x03 Reserved
0x04 Reserved
0x05 Reserved
0x06 FrameValid
0x07 Busy Output 2
0x08 Follow corresponding input
(Inp1  Out1)
0x09 PWM (=pulse-width modulation) Only Guppy board level cameras
0x0A..0x1F Reserved
Table 29: Output routing
Note

The output mode 0x08 is not available for output pins
directly tied to an input pin.