Video settings, Card recording, Only for the camera with – eLine Technology SNI-CamSetup User Manual
Page 33: Card recording function
<9>
Video settings
<9.1>
SD card recording - only for the camera with SD card recording function
Click "SD card recording, the user can set the video: behind the camera red REC lamp is a good video to set the reference.
The red light indicates the video settings, but did not reach the recording conditions (for example, did not trigger linkage video);
flashes that are video; goes out to indicate
Stop recording, and there is no other video settings.
Note: all video settings, and finally click "start recording". "Start recording" is equal to start recording mechanism, waiting for the
video trigger condition to start recording. "Start recording" button to start recording belongs to the external start recording. You do
not need to click "start recording" to start.
图 34
Config SD:
Start recording: when clicked, will be based on pre-set conditions video.
Stop recording: click, immediately stop recording.( This button when the camera is
recording)
Delete SD files: Clear SD card recording
Bootup recording: the camera starts automatically start recording.
Manual recording: start recording only when the user presses the record button on the
camera.
Audio included: selected audio input source video input.
Normal recording: no trigger mechanism based on pre-set video.
Event recording: the user can pre-set trigger conditions to trigger recording.
The trigger condition is a regional one, two, three linkage trigger, and the DI input trigger.
Storage Policy:
Overwrite: the the early video files are automatically deleted when the SD space is full to
free up space for a new video.
Stop when full: Do not remove the earlier video, stop recording automatically after the
expiry of the SD space.
enable schedule: See below Recording schedules settings
Movement detection: Refer to the following movement detection section
Video quality: see below video quality part
SD card status: Contains the SD card can be the size of the actual recording space. The
recorded time and the remaining space available recording time.
Note: The remote web playback available SD card recording, operations, see <12> remote
playback
Video image quality settings:
The user can according to their needs, set the appropriate image quality.
Note: too much FPS RES will need to the larger BPS, take up more disk
space.
FPS: frames per second (fluency)
RES: image resolution (Resolution)
BPS: bit rate (bandwidth demand)
eLine Sniper Camera Setup Manual
eLineTechnology.com
32