Introduction, Tools, Instruction – FlexLink XT (макс. 30 кг) Тех. обслуживание User Manual
Page 21: 1 remove the roller bridge between the conveyors, 3 lift off the motor from the drive shaft, Replace chain on xt, Conveyor module – catenary drive unit” on, Replace, Chain on xt conveyor module – catenary drive
Advertising
2002-12-11
21
Replace chain on XT conveyor module – Catenary drive unit
Introduction
The chain only runs on top of the conveyor.
Tools
Instruction
Box wrench
10 mm
Slip joint pliers
Pin insertion tool
Screwdriver
1 Remove the roller bridge between the
conveyors.
2 Use the screwdriver to remove the plastic cap
on the motor. Loosen the screw for the motor
with the 10 mm box wrench.
3 Lift off the motor from the drive shaft.
Advertising