FlexLink XT (макс. 30 кг) Тех. обслуживание - Manual (Page 47)

2002-12-11 47
Replace motor on XT transfer unit XTPT M1
Introduction
Valid for XT transfer unit type M1.
Tools
Instruction
Phillips screwdriver
Allen key
5 mm
Box wrench 10 mm
1 Remove the screws (8×) on the transfer unit
covers on both sides. Use the Phillips
screwdriver. Remove the covers.
2 Remove the screws (2x) holding the motor, use
the 5 mm Allen key and the 10 mm box wrench.
Replace the old motor and fasten the screws
using the 5 mm Allen key and the 10 mm box
wrench. Make sure to hook the driving belt on the
new motor.
Fit the covers. Fit and tighten the screws (8×) on
the transfer unit covers on both sides. Use the
Phillips screwdriver.