FlexLink XT (макс. 30 кг) Тех. обслуживание - Manual (Page 32)

2002-12-11 32
Replace motor on XT conveyor drive unit – Side mounted
Introduction
Valid for motor types L and R (side mounted motor).
Tools
Instruction
Box wrench 10 mm
Box wrench 13 mm
Screwdriver
1 Disconnect all electrical wiring from the motor.
Use the screwdriver to remove the plastic cap on
the motor. Loosen the screw for the motor with
the 10 mm box wrench.
2 Detach the motor from the drive shaft. Dismount
the torque arm and fit it on the new motor, use
the 13 mm box wrench.
3 Fit the motor on the drive shaft and make sure
that the torque arm is placed on the rubber tube.
Tighten the screw using a 10 mm box wrench. Fit
the plastic cap.
CAUTION! Make sure that the torque arm fork
has entered the cage in a correct way. An
unlocked rotating motor can cause personal
injury.