Clear-Com HX System Frames - Manual (Page 14)

Tip: For detailed information about installing a particular matrix (matrix frame) or interface
frame in the rack, see the appropriate guide in the Eclipse HX documentation set. For matrix
frames, see the:
• Eclipse HX-Omega User Guide.
• Eclipse HX-Median User Guide.
• Eclipse HX-Delta User Guide.
• Eclipse HX-PiCo User Guide.
For interface frames, see your IMF-3 or IMF-102 documentation.
3.2.2 Installing the cabling
Install the intercom cables between the Eclipse HX matrix (matrix frame) and the other
system components (user panels and interface frames).
Clear-Com recommends that you route cables before wiring the connectors to the cables.
Tip: For more information about routing cables, see 4 Locating System Components.
3.2.3 Connecting the other system components to the matrix frame
Connect the system components / devices (such as the external computer for EHX, interface
frames and modules, and external alarms) to the matrix frame.
For a wiring scheme / connection overview, see 3.1.3 Determine cabling and wiring
scheme requirements > Wiring schemes above.
Tip: For detailed information about wiring schemes, see 6 Wiring System Components.
3.2.4 Connecting to mains AC power
Eclipse HX matrix frames and interface frames (IMF-3)
Eclipse HX matrix frames have two separate AC power connectors for two separate power
supplies in the system. Either power supply will completely power a system, providing 100%
power redundancy. If the two power supplies are connected to different AC power sources
and one of the power supplies loses power, the other will continue to operate the system.
AC voltage for the matrices and the PSU-101 can be 100 - 240 VAC without any switching
or fuse changes.
Each component of the Eclipse HX system requires AC power except for the IMF-3 and
some interface modules. The IMF-3 requires an external power supply. The XP-type
expansion panels receive power from the panels to which they are connected.
If you are installing an IMF-3, install the DC power cables that connect the power supply to
the frame. For the matrix frame and each connected component, install and connect the
mains AC power cables.
Tip: For further information, see 5 Powering System Components.
V-Series panels
Each V-Series panel has an external power supply and a removable cradle to hold the
external power supply.
AC voltage for these panels can be 100 - 240 VAC without any switching or fuse changes.
14 Eclipse HX Matrix Frame Installation Guide