Clear-Com HX System Frames User Manual

Page 52

Advertising
background image


d. Label the second control REC1.

e. Add the Radio In route to REC1.

f. Add the E & M relay / GPO (the relay associated with the first configured port

on the E1 / T1 direct E-QUE card) to REC1.

Note:

This relay receives the E & M signal from the ship’s radio into the matrix.

4. In Configuration > Cards and Ports > Frame and Module GPIs:

a. Select the appropriate E & M enabled GPI (the GPI associated with the first

configured port on the E1 / T1 direct E-QUE card).

b. In Advanced Settings, enable / select the trigger for the PTT1 control.

Note

:

When the E & M signal is received from the shore-based communications
system at the E1 / T1 direct E-QUE card, the E & M signal is sent to the FOR-
22 / radio.

5. In Configuration > System Ports:

a. Select the port for the FOR-22 interface module.

b. In Advanced Settings > VOX action, select the REC1 control from the drop-

down menu.

c. In Advanced Settings > VOX action > Voice Op. Switch, adjust the Audio

Off Delay and Audio Detect Threshold as required.

Note:

When VOX is detected, the E & M signal for the FOR-22 / radio is sent via the
E1 / T1 direct E-QUE card to the shore-based communications system.

52

Eclipse HX Matrix Frame Installation Guide

Advertising
This manual is related to the following products: