Clear-Com HX System Frames - Manual (Page 38)

6.3 Connecting the matrix frame to an Ethernet network
To connect a matrix frame to an Ethernet network (WAN / LAN), use:
• The LAN1 connector (a standard RJ-45 Ethernet connector) on the rear of an
Eclipse HX-Omega, Eclipse HX-Median or Eclipse HX-Delta matrix frame.
Note:
LAN1 is the default connector on the Eclipse HX-Omega / Eclipse HX-Median /
Eclipse HX-Delta matrix frame . The LAN2 connector (which is also a standard RJ-45
Ethernet connector) is not configured when it leaves the factory and must be
enabled in EHX before it can be used.
• The LAN connector (a standard RJ-45 Ethernet connector) on the rear of the Eclipse
HX-PiCo.
For Eclipse HX-Omega, Eclipse HX-Median and Eclipse HX-PiCo, a ferrite core must be
added to the socket end of each Ethernet cable to comply with European EMC standards. A
suitable ferrite core is Würth Electronik part: 74271132.
Shielded CAT5 cable is recommended for Electro Magnetic Compliance in EC countries.
See also 6.2.1 Ethernet connection to the PC.
Pin Function
Pin 1 Transmit data +
Pin 2 Transmit data -
Pin 3 Receive data +
Pin 4 N / C
Pin 5 N / C
Pin 6 Receive data -
Pin 7 N / C
Pin 8 N / C
Table 10: Pin assignments for LAN connectors
Note:
Shielded CAT5 cable should be used, where possible.
38 Eclipse HX Matrix Frame Installation Guide