Clear-Com V12PDDXY - Manual (Page 132)

2. Rotate the front panel, so that the controls and display will face upwards when wall
mounted:
a. Remove the eight countersunk screws that hold the front of the panel in place
(the countersunk screws are located on the ends of the panel, four on each
end).
Figure 160: Countersunk screws in desktop panel
b. Retain all the screws and remove the front panel assembly.
Note:
The cables connecting the front panel electronics to the main PCB are long
enough to allow the panel front to be removed and rotated without having to
unplug any of the cables.
c. Rotate the front panel 180 degrees taking care not to pull on any of the cables
and reposition it. Ensure that no cables are trapped before refitting the
screws.
d. Apply pressure to the panel front to align the screw holes and fit the top and
bottom screws loosely on each side before fitting the remaining screws and
tightening all the screws.
When completed the front panel will be upside down when the panel is
standing on a flat surface.
132 V-Series Panels User Guide