Hach-Lange ORBISPHERE 410 User Manual - Manual (Page 23)

21
Installation
3.3.4 Connection panel (bottom of instrument)
Front panel door
A square key is provided to open the instrument front panel locks. The two locks are located on
the right side of the instrument on the top and bottom panels (bottom panel indicated with the
number 8 in
Figure 4 below).
The front panel can be easily pivoted to the left as shown below. To retain the instrument
waterproof tightness, make sure the seal is clean and in good condition before closing the front
panel.
Figure 4 Wall and pipe mount connection
panel
1. Power cable. The type of connection will
vary depending on the instrument
specification (see
Connection to mains
power supply on page 26 )
2. USB-B client 4 pin connector. Use the
adapter cable (see
USB-B client adapter
cable on page 26 )
3. Ethernet cable gland
4. Sensor cable gland
5. USB-A host connector for mass storage
device
6. Input/Output 2 cable gland
7. Input/Output 1 cable gland
8. Keylock (bottom panel)