Hach-Lange DR 3900 User Manual - Manual (Page 39)

39
Standard programs
5.2.7.3 Print data continuously
If all readings are to be printed out automatically straight after
measurement, the use of a continuous form printer is
recommended, e.g. the 4" paper thermal printer. Refer to
Section 9, page 137 .
1. Connect the thermal printer to a USB type A port.
2. Press PC & Printer in the "Instrument Setup" menu.
A list with information about the connections opens.
3. Highlight Printer.
4. Press Setup to display the Printer Setup screen.
5. Select Auto-Send: On to send all measured data
automatically to the Thermal printer.
5.2.7.4 Network setup
The DR 3900 supports communication in local networks. To
establish Ethernet communication in networks, special
configuration is required. The manufacturer recommends support
from a network administrator. Only use a shielded cable
(e.g. STP, FTP, S/FTP) with a maximum length of 20 m for the
Ethernet port. This section describes the setting options for the
photometer in relation to network communication.
The connection parameters must be configured for data transfer
to a PC or connection to a network.
1. Press PC & Printer in "Instrument Setup".
2. Press Network>Setup.
3. Press On.
4. Press IP address.
An IP address is used to send data from a sender to a
pre-defined recipient.
• If the IP for the DR 3900 is automatically issued in the
network, no further settings are necessary. A hostname
can optionally be assigned.
• If the instrument address is fixed, the connection must be
configured.