Hach-Lange DR 3900 User Manual - Manual (Page 46)

46
Standard programs
5. Select the data to be sent.
The following options are available:
• Single point: only this selected reading will be sent
• Filtered data: only readings that correspond to the set
filters will be sent
• All data: all data in the selected data category will be
sent.
6. Press OK to confirm.
Note: The number in parentheses is the total number of data sets
assigned to this selection.
5.3.1.4 Delete stored data from the data log
1. Press Recall Data from the Main Menu.
2. Press Data Log>Options>Delete.
3. Highlight Single point, Filtered data or All data and press
OK to confirm.
Note: The number in parentheses is the total number of data sets
assigned to this selection.
5.3.2 Control charts for data from the AQA Log
1. Press Recall Data in the Main Menu.
2. Press AQA Log.
A listing of the stored data is displayed.