Controlled Products Systems Group RSL12V - Manual (Page 18)

Outside
Pr
oper
ty
Inside Pr
oper
ty
Outside
Pr
oper
ty
Inside Pr
oper
ty
Outside
Pr
oper
ty
Inside Pr
oper
ty
GATE 2
SET
CLOSE
LIMIT
GATE 1
G
SET
CLOSE
LIMIT
GATE A
SET
OPEN
LIMIT
N N
LEARN
LIMITS
SET
CLOSE
DIAGNOSTIC
GATE 1
SET
CLOSE
DIAGNOSTIC
GATE 1
SET
OPEN
LIMIT
SET
CLOSE
LIMIT
SET
OPEN
LIMIT
SINGLE GATE RIGHT-HAND SIDE
Close the gate.
Press and release the LEARN LIMITS button. The SET OPEN LIMIT LED will blink.
PROGRAM OPEN
Press and hold the GATE 1 left button to move the gate to the desired OPEN
position. When the gate is in the desired position, release the button.
NOTE: The GATE 1 right and left buttons can be used to jog the gate back and
forth as needed.
When gate is in the desired OPEN position, press and release the
LEARN LIMITS button. The control board will beep and the SET CLOSE LIMITS
LED will blink.
PROGRAM CLOSE
Press and hold the GATE 1 right button to move the gate to the desired CLOSED
position. When the gate is in the desired position, release the button.
NOTE: The GATE 1 right and left buttons can be used to jog the gate back and
forth as needed.
When gate is in the desired CLOSED position, press and release the
LEARN LIMITS button. The control board will beep and the SET CLOSE LIMITS
LED will stop blinking.
Programming is now complete. If the SET OPEN LIMIT LED continues to blink, repeat
programming. If the problem continues, see below.
Test the limits by pressing the SINGLE BUTTON to open and close the gate.
4
"BEEP"
6
"BEEP"
LEARN LIMITS Button
LEARN LIMITS Button
GATE 1 Left Button
3
GATE 1 Right Button
5
ADJUSTMENT
» LEARN LIMITS
IF THE LIMITS WILL NOT PROGRAM
Disconnect the operator by pressing the reset switch to RESET/DISCONNECT.
Manually close the gate.
Remove the learn limit cover and move the learn limit nut to the center
position.
Press the reset switch to NORMAL OPERATION.
Program the limits again.
1
2
3
4
LEARN LIMITS Button
2
1
Learn Limit Cover
Learn Limit Nut
Learn Limit Switch
3
4
6
5
2
1
17