Controlled Products Systems Group RSL12V - Manual (Page 8)

To prevent SERIOUS INJURY or DEATH from a moving gate:
• Entrapment protection devices MUST be installed to protect anyone who may
come near a moving gate.
• Locate entrapment protection devices to protect in BOTH the open and close
gate cycles.
• Locate entrapment protection devices to protect between moving gate and
RIGID objects, such as posts or walls.
ADDITIONAL FEATURES
To reduce the risk of SEVERE INJURY or DEATH:
• READ AND FOLLOW ALL INSTRUCTIONS.
• ANY maintenance to the operator or in the area near the operator MUST NOT
be performed until disconnecting the electrical power and locking-out the power
via the operator power switch. Upon completion of maintenance the area MUST
be cleared and secured, at that time the unit may be returned to service.
• Disconnect power at the fuse box BEFORE proceeding. Operator MUST be
properly grounded and connected in accordance with national and local
electrical codes. NOTE: The operator should be on a separate fused line of
adequate capacity.
• NEVER let children operate or play with gate controls. Keep the remote control
away from children.
• ALWAYS keep people and objects away from the gate. NO ONE SHOULD CROSS
THE PATH OF THE MOVING GATE.
• Test the gate operator monthly. The gate MUST reverse on contact with a rigid
object or stop when an object activates the non-contact sensors. After adjusting
the force or the limit of travel, retest the gate operator. Failure to adjust and
retest the gate operator properly can increase the risk of INJURY or DEATH.
• Use the emergency release ONLY when the gate is not moving.
• KEEP GATES PROPERLY MAINTAINED. Read the owner’s manual. Have a
qualified service person make repairs to gate hardware.
• ALL maintenance MUST be performed by a LiftMaster professional.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted
and there are no obstructions to door travel.
• To reduce the risk of FIRE or INJURY to persons use ONLY LiftMaster part
29-NP712 for replacement batteries.
• SAVE THESE INSTRUCTIONS.
MAINTENANCE AND OPERATION
To protect against fire and electrocution:
• DISCONNECT power and battery BEFORE installing or servicing operator. For continued protection against fire:
• Replace ONLY with fuse of same type and rating.
TROUBLESHOOTING
SAFETY
» IMPORTANT SAFETY INFORMATION
• ALWAYS wear protective gloves and eye protection when changing the battery
or working around the battery compartment.
7