Controlled Products Systems Group RSL12V - Manual (Page 20)

Outside Pr
oper
ty
Inside Pr
oper
ty
Outside
Pr
oper
ty
Inside Pr
oper
ty
Outside
Pr
oper
ty
Inside Pr
oper
ty
GATE 2
SET
CLOSE
LIMIT
GATE 1
G
SET
CLOSE
LIMIT
GATE A
SET
OPEN
LIMIT
N N
LEARN
LIMITS
SET
CLOSE
DIAGNOSTIC
GATE 1
CLOS
DIAGNOSTIC
GATE 1
FORCE
GATE 2
SET
CLOSE
LIMIT
LE
LIMITS
FORCE
GATE 2
SET
CLOSE
LIMIT
LE
LIMITS
SET
OPEN
LIMIT
SET
CLOSE
LIMIT
SET
OPEN
LIMIT
SET
CLOSE
LIMIT
Outside
Pr
oper
ty
Inside Pr
oper
ty
Outside Pr
oper
ty
Inside Pr
oper
ty
DUAL GATE (RIGHT-SIDE PRIMARY OPERATOR)
Close the gate.
Press and release the LEARN LIMITS button. The SET OPEN LIMIT LED will blink.
PROGRAM OPEN
Press and hold the GATE 1 left button to move the right operator to the desired
OPEN position. When the gate is in the desired position, release the button.
NOTE: The GATE 1 right and left buttons can be used to jog the gate back and
forth as needed.
Press and hold the GATE 2 left button to move the left operator to the desired
OPEN position. When the gate is in the desired position, release the button.
NOTE: The GATE 2 right and left buttons can be used to jog the gate back and
forth as needed.
Press and release the LEARN LIMITS button. The control board will beep and the
SET CLOSE LIMITS LED will blink.
PROGRAM CLOSE
Press and hold the GATE 2 right button to move the left operator to the desired
CLOSED position. When the gate is in the desired position, release the button.
NOTE: The GATE 2 right and left buttons can be used to jog the gate back and
forth as needed.
Press and hold the GATE 1 right button to move the right operator to the
desired CLOSED position. When the gate is in the desired position, release the
button. NOTE: The GATE 1 right and left buttons can be used to jog the gate
back and forth as needed.
Press and release the LEARN LIMITS button. The control board will beep and the
SET CLOSE LIMITS LED will stop blinking.
Programming is now complete. If the SET OPEN LIMIT LED continues to blink, repeat
programming. If the problem continues, see below.
Test the limits by pressing the SINGLE BUTTON to open and close the gate.
ADJUSTMENT
» LEARN LIMITS
GATE 2 Left Button
GATE 1 Left Button
GATE 2 Right Button
GATE 1 Right Button
3
4
6
7
5
"BEEP"
LEARN LIMITS Button
8
"BEEP"
LEARN LIMITS Button
IF THE LIMITS WILL NOT PROGRAM
Disconnect both operators by pressing the reset switch on each operator to
RESET/DISCONNECT.
Manually close each gate.
Remove the learn limit cover and move the learn limit nut to the center position
on both operators.
Press the reset switch to NORMAL OPERATION on both operators.
Program the limits again.
1
2
3
4
LEARN LIMITS Button
2
1
Learn Limit Cover
Learn Limit Nut
Learn Limit Switch
2
3
4
6
7
8
5
1
19