Liquid Controls SP4000 - Manual (Page 116)

113
SP4000 Flow Computer
12.3 Error Messages:
Cause
Power has been interrupted
Possible transient
Possible Improper wiring or
usage Message Transmission
failure.
Operator Error
Print buffer full, Data may be
lost
Temperature or pressure input
has gone below the saturated
steam range of the internal
steam tables
Temperature or pressure input
has gone below or exceeded
the range of the internal steam
tables
Flow input has exceeded input
range (if stacked, may be lo or
hi transmitter)
Input 1 signal from sensor has
exceeded input range
Input 2 signal from sensor has
exceeded input range
Input 3 signal from sensor has
exceeded input range
Open circuit detected on flow
input (if stacked, may be lo or hi
transmitter)
Open circuit detected on input 1
Open circuit detected on input 2
Open circuit detected on input 3
Open circuit detected on RTD 1
input
Short circuit detected on RTD 1
input
Remedy
Acknowledge Error
Remedy not required
Acknowledge Error
Remedy not required
Check wiring and
communication settings
/ protocol
Repeat Calibration
Check paper and
printer connections
Check application,
Insure that all sensors
are working properly
Check application,
Insure that all sensors
are working properly
Check sensor
calibration
Check sensor
calibration
Check sensor
calibration
Check sensor
calibration
Check wiring and
sensor
Check wiring and
sensor
Check wiring and
sensor
Check wiring and
sensor
Check wiring and RTD
Check wiring and RTD
Error Message
POWER FAILURE
WATCHDOG TIMEOUT
COMMUNICATION
ERROR
CALIBRATION ERROR
PRINT BUFFER FULL
WET STEAM ALARM
OFF FLUID TABLE
FLOW IN OVERRANGE
INPUT 1 OVERRANGE
INPUT 2 OVERRANGE
INPUT 3 OVERRANGE
FLOW LOOP BROKEN
LOOP 1 BROKEN
LOOP 2 BROKEN
LOOP 3 BROKEN
RTD 1 OPEN
RTD 1 SHORT
NOTE: The 24 VDC output has
a self resetting fuse.