Magnum Venus Plastech PATRIOT SSB Auto - Manual (Page 20)

Patriot SSB Auto Instructions Issue 05 30/06//08 Page 20 of 43
9. Properly clean Piston (PAT-LS-1007), Fluid Rod (PAT-LS-1008) and Piston Valve (PAT-LS-1009),
check ball seat area of the Piston Valve for damage or debris.
10.
Install a new O-Ring (O-E-3-916) on the Piston Valve, lubricate O-Ring and threads with Red
Grease (6706-2-1 1 oz).
11.
Lightly grease the Piston Ball (VLS-2427 and place in the Piston Valve.
12. Install the Spring (PAT-LS-1010) onto the Piston Ball, narrow side against the Ball.
13. Place the back of the Spring Retainer (PAT-LS-1011) on top of the Spring and into the grove in the
Piston Valve, using a pair of Pliers squeeze the Spring Retainer (PAT-LS-1011) and push the front
into the grove.
14. Screw the Piston Valve Assembly into the bottom of the Piston and tighten firmly. Check that the
Fluid Rod (PAT-LS-1008) is tightened onto the Piston (PAT-LS-1007).
• Pump Assembly –
1. With the assembled Inlet Body mounted
in the vise slowly and firmly push the
Piston and Fluid Rod assembly all the
way down into the Inlet Body.
2.
Carefully and firmly
push the assembled
Outlet Body onto the
Inlet Body until the
Fluid Rod extends
though the Packing
Nut.
NOTE: Use care not to drop the Piston Ball as it will be damaged.