Magnum Venus Plastech PATRIOT SSB Auto User Manual

Page 26

Advertising
background image

Patriot SSB Auto Instructions Issue 05 30/06//08

Page 26 of 43


The Catalyst Over pressure valve (OPV) is a pressure switch designed to stop the
machine pumping in the unlikely event of catalyst fluid section blockage causing high
pressure. This unit has been factory set and tested by MVP. It will trigger the machine
pump OFF for pressures higher than 24 bar (350 psi)

The OPV is mounted inside the machine covered chassis on the left hand side and
secured on a robust nylon clip.

If for any reason the user needs to install new O ring seals (0750) then only the front
Stainless steel body (1032) should be unscrewed from the pressure switch brass body.
Do not disturb the Brass body end cap setting as this will invalidate the factory pressure
setting.








9.4 Catalyst Ratio arm - MotoCat

Advertising