Micromod Micro-PWC: 53PW6000 MicroPWC Operators Manual - Manual (Page 127)

Micro-PWC OPERATOR’S MANUAL
Utilities 113
Click Yes in the confirmation box to restore the selected file, or click No to abort the restore operation.
If Yes is selected, the Restore window ( Figure 11-10 ) will be displayed.
The Restore window is used to select which type of data is to be restored from the File (volume) on the
tape. Only those radio buttons which represent data included in the specified File (e.g., File Number 1) can
be selected; buttons which do not represent data in the specified file are “insensitive”, and clicking on them
will have no effect. If the All button is selected for an information type, all information for that type in the
selected File will be restored. To restore only specific items, click the Selected button for that information
type. A window similar to
Figure 11-11 will be displayed. Click the desired files in the list to select them for
restoration.
.
Figure 11-9. File Restore Confirmation Box
Figure 11-10. Restore Window
✎ NOTE
In the case of System Configuration Data, select All to restore data
for all Micro-PWC configuration data types. This is the equivalent of
clicking on the Selected button, then selecting all the Micro-PWC
configuration data types available in the selected backup file. (If a
particular data type was not included when the backup was made,
then the entry for it is stippled out and it cannot be selected.)