Diamond Products FZ-4S - Manual (Page 17)

FZ-4S Set-up
FZ-4S_e_0205.fm Page 17
 6HOHFWLQJ WKH VDZ EODGH
z Select the saw required blade diameter
according to the requirements of the cut
and the technical conditions.
3UHFXW
$QFKRULQJ RSWLRQV IRU VDZ EODGHV
External dia.: 450 - 2200 mm
Dia. location hole: 60 H7 mm
Quick-release flange for
normal cuts
XS WR GLD  PP
2 x M12 hexagon head cap
screw with blade cover
Quick-release flange for
normal cutting
IURP GLD  PP
6 x M8 countersunk head screw
on dia. 130mm graduated circle
2 x M12 hexagon head cap
screw with blade cover
Quick-release flange for
IOXVK FXWWLQJ 6 x M8 countersunk head screw
on dia. 130mm graduated circle
$QFKRULQJ VDZ EODGH XQLW WR ZDOO VDZ
Saw blade with quick-
release flange to wall saw 1 x central screw
:KDW FXWWLQJ GHSWK GR \RX ZDQW WR DFKLHYH"
The “Cutting depth” table shows how big the
saw blade must be according to the cutting
depth.
&XWWLQJ GHSWK H[DPSOH
Sawing an opening in a 35 cm thick concrete
wall:
- The saw blade must be
 PP in size
(see “Cutting depth” table).
- At the maximum plunging depth the saw blade will
have a
 FP RYHUODS at both ends of the cut (see
“Overlap” table).
A precut of dia. 800 mm is recommended for
all work.
Use the following screws only:
Countersunk head screw M8x16,
JUDGH  , order No. 97182 .
Use the following screws only:
Hexagon head cap screw M12x35, order no. 969911
Use the following screws only:
Central screw M12x70, order no. 999255
6DZ
EODGH
GLD
&XWWLQJ
GHSWK
3UHFXW UHTXLUHG"
800 30
1R
precut
required
900 35
1000 40
1200 50
Precut with small
blade required
1500 67
1600 72
1800 82
2000 92
2200 102