Diamond Products FZ-4S - Manual (Page 21)

FZ-4S Set-up
FZ-4S_e_0205.fm Page 21
3URFHGXUH
z Mark cutting line on the concrete
z Mark dowel line at a distance of 22 cm.
(The same distance applies for flush cuts)
z Drill dowel hole and fit dowel according to
dowel manufacturer’s instructions
z Mount V-rail supports (9) on V-rails (1).
z Mount rail unit on concrete and align using
cut guide (10)
z Align rail unit with adjusting foot (8), so that
all adjusting feet (8) and the adjusting
screws (4) are supported by the concrete.
z Tighten rail unit (1)
5DLO OLPLW VWRS
z Mount rail limit stop on the end of the rail, so
that the wall saw head cannot fall off the
rail.
Clearance between rail supports:
- where a single rail is used, as high as possible
- where a number of rails are used, evenly distributed
along the entire length of rail.
Once rail unit has been mounted
check adjusting nut (3) and
clamping block (6) anchoring