Diamond Products FZ-4S - Manual (Page 37)

FZ-4S Maintenance
FZ-4S_e_0205.fm Page 37
 0DLQWHQDQFH
 0DLQWHQDQFH WDEOH
Service the system within the indicated
intervals in order to ensure:
- Safety for the operator
- Optimum performance
- Optimum reliability at all times
8QFRXSOH
wall sawing system
prior to performing maintenance
work on the unit
0DLQWHQDQFH LQWHUYDO $FWLRQ 5HPDUNV
after first 50 h Toothed wheel swivel arm oil change Fill with 1 dl oil
weekly Check prism guides for wear Replace, EHIRUH anchoring screws of
prisms touch the rail
weekly Check couplings for
- leaks
- damage Replace leaky or damaged couplings
weekly Grease Y-slide guides grease nipple 2-3 grease injections
weekly Check water couplings for
- leaks
- damage Replace leaky or damaged couplings
annually Change bearing housing grease Fill with 600 g gear grease
annually Major service Must only be performed by
HYDROSTRESS or a HYDROSTRESS
authorised representative
every 100 h Toothed wheel swivel arm oil change Fill with 1 dl oil
Correct maintenance procedures are described on the following pages.