DoorKing 1838 Telephone Access Plus - Manual (Page 23)

1838-066-D-1-12 Page 23
2.4 System Parameters Programming
IMPORTANT! We strongly suggest that you read these programming instructions in their
entirety before beginning any manual programming of the 1838 Access Plus system.
Programming from the Keypad
Follow the programming instructions as described in each section of this manual. The system will
prompt you with short tones (beep) when programming steps have been followed correctly and with a
long tone (beeeeeep) when the programming step is ended.
Programming with a Touch-Tone Telephone
NOTE: A telephone line must be connected to the 1838 to program the system via this method.
Follow these steps when programming the 1838 from an off-site location using a touch-tone
telephone. NOTE: The 1838 must be programmed to answer incoming calls, section 2.4.3.
1. Call the telephone number of the phone line connected to the 1838. The 1838 will answer
with a short beep after the programmed number of rings.
2. Follow the programming instructions as described in each section of this manual. The system
will prompt you with short (beep) tones when programming steps have been followed
correctly.
3. When complete, hang up.