Nova-Tech PGL Series - Manual (Page 12)

6.0 BASIC OPERATION
6.1 INITIALISATION
1) When the balance is first switched on, it will display the balance serial number
(if set), software revision, model capacity and then all segments on the display
will be shown. Overall the time taken is usually 5 ‐10 seconds.
2) If a passcode has been set, the display will show “PASSCODE” and the main
display will show a zero. In this case you must enter the passcode to continue
using the numeric entry method (see section 5.1). A different passcode may
be set for a Supervisor to weigh or to have access to the selected User menus.
If the passcode has not been set the balance will continue as below.
3) The display will show zero reading along with the zero symbol “→0←” and
the weighing unit last used. If automatic time calibration is enabled the
balance will calibrate after power up and again after the pre‐set time interval.
12 | P a g e © Adam Equipment Company 2008