Nova-Tech PGL Series - Manual (Page 7)

3.3 LEVELLING THE BALANCE
After placing the balance in a suitable place, level it
by using the spirit level on the rear of the balance. To
level the balance turn the two adjustable feet at the
rear of the balance until the bubble in the spirit level
is centered.
3.4 WARM‐UP TIME
Attach the power supply cable to the connector on
the rear of the balance. Plug the power supply
module into the mains. The display will indicate the
balance serial number (if set) and the software
revision number followed by the capacity of the
balance. Next the balance will run a self‐test by
displaying all segments followed by a symbol
indicating the balance is in busy mode. If the balance
serial number is not set the display will show dashes.
The display will show zeroes accompanied by the
О0Н symbol.
Before you start weighing, you have to wait for the balance to achieve a stable
internal temperature.
A stable sign ~ is shown when the balance is in
stable condition. It will turn off if the balance is not
stable.
Exact zero is shown when the “О0Н “ symbol is on
to the left of the display area.
7 | P a g e © Adam Equipment Company 2008