Nova-Tech PGL Series - Manual (Page 30)

12.0 SUPERVISOR MENUS
Pressing the [Setup] key while in normal weighing gives access to the menus.
1) When [Setup] is pressed and passcodes are not enable the display will show
the message “SUPERVISOR”. If passcodes are enabled, the balance will ask for
it by displaying “PASSCODE 0”
2) If a wrong code is entered an “ERROR CODE” message will flash and the balance
will return to weighing mode
3) If the passcode has been enabled and entered, the balance will allow the
operator to access the Supervisor’s menus
4) When the display shows “SUPERVISOR” press [Enter] to view the topics that
can be modified
5) From this menu the user can enable/disable weighing units or modes, set
balance parameters for the conditions, set time and date, set parameters for
the RS‐232 interface, calibration parameters and security parameters
6) The [Up] and [Down] keys will cycle through the main headings, pressing the
[Enter] key will enter the heading and sub‐parameters or options can be set.
Press [Mode] to come out of a sub‐menu or to [Esc] to return to normal
weighing from any menu
12.1 ENABLE WEIGHING UNITS
1) When “UNITS” is displayed, press [Enter]. The display will show the symbol for
the first unit, e.g. kilogram, kg, together with its enable state “OFF” or “On”.
The user can then enable or disable the carats unit by using [Up] or [Down].
Pressing [Enter] will confirm the setting and will advance to the next weighing
unit. Repeat for each weighing unit in turn. Gram is always set to “On”
2) Press [Mode] to advance to setting of the next menu or press [Esc] to return
to normal weighing
30 | P a g e © Adam Equipment Company 2008