Nova-Tech PGL Series - Manual (Page 35)

12.6 PASSCODES
To enable the security features in this balance it is necessary to set passcodes.
There are 2 passcodes called Operator Passcode and Supervisor Passcode. The
Operator Passcode allows an authorised user to operate the basic weighing
functions of the balance but will not allow access to the Supervisor Menus if the
Supervisor Passcode has been set.
To change or disable a Passcode it will be necessary to enter the current
passcode.
Press [Enter] when “PASSCODES” is displayed to enter this section.
Select either Operator or Supervisor passcode using the [Up] or [Down] keys.
Press [Enter] to select the passcode to change.
Press [CAL] to enter the current passcode (OLD) first then enter a new passcode
if desired. Use the numeric entry method (see section5.1). A passcode set to
zero will disable the security feature and allow unlimited access.
Forgotten Passcodes
Keep a record of the passcode to ensure you can access this section again. If
however you have forgotten your passcode you can still gain access by entering a
universal code.
If you have forgotten the current passcode a code of “15” will always allow you to
enter the Supervisor area.
Using the Supervisor menus go to the PASSCODE section and reset the operator or
Supervisor passcode using the “15” code as the old number when asked.
35 | P a g e © Adam Equipment Company 2008