Nova-Tech pH 310 - Manual (Page 20)

39
38
P6.0: Resetting to factor
y default settings
A
vailable in pH 310 meter only
In the pH 310 meter
, Pr
ogram 6 lets you r
eset all parameters to factory default
settings. This clears all calibration data, memory
, and any other setup functions you
might have changed.
MEAS
SETUP
A
MEAS
SETUP
B
8.8
From measurement mode 1.
Press Setup key
to enter Set Up mode.
2.
Press the
▲
and
▼
keys
to scr
oll thr
ough
subgr
oups until you view parameter
P6.0.
See figur
e
3.
Press the ENTER
key
to enter
parameter P6.0.
See figur
e
4.
Press the
▲
and
▼
keys
to toggle
between NO
and
YES.
• NO r
etains curr
ent settings
•
YES
resets to factory default settings
5.
Press the ENTER
key
to confirm selec-
tion and to r
eturn to the subgr
oup menu.
Pr
ess the CAL/MEAS key to r
eturn to
measur
ement mode. A B
11.
Press the ENTER
key
to confirm the
date and move to “hour” selection. The “hour” digits will flash.
See figur
e
12.
Press the
▲
and
▼
keys
to toggle to
the corr
ect hour
. Note the “AM” and
“PM” indicator on the lower portion of the display
.
13.
Press the ENTER
key
to confirm the
hour and move to “minute” selection. The “minute” digits will flash.
See figur
e
14.
Press the
▲
and
▼
keys
to toggle to
the corr
ect minutes.
15.
Press the ENTER
key
to confirm the
minutes and move to “second” selec- tion. The “second” digits will flash.
See figur
e
16.
Press the
▲
and
▼
keys
to toggle to
the corr
ect seconds.
17.
Press the ENTER
key
to confirm
the seconds and r
eturn to “century”
selection.
18.
Press the CAL/MEAS
key
to r
eturn
to the subgr
oup menu. Pr
ess the
CAL/MEAS key again to r
eturn to
measur
ement mode.
Notes Pr
ess the CAL/MEAS key at any point
while setting the time to r
eturn to the
subgr
oup menu.
SETUP
AM
F
F
SETUP
AM
G
G
SETUP
AM
H
H
http://www.novatech-usa.com/Products/Laboratory-Equipment-Supply-Products Tel: (281) 359-8538 Toll Free:(86
6) 433-6682