Nova-Tech Digi-Sense Termperature Controller RS (Standard Models) - Manual (Page 11)

8
SETUP PROCEDURE
NOTES:
a. At any time during the setup procedure, you may return to
the previous screen by pressing and holding down the LEFT
arrow key and then pressing the MENU key.
b. For experienced operators, a flow chart may be used for set-
up and operation. Refer to Appendix A.
c. The setup mode can only be entered when the temperature
controller is stopped.
1. Set the ON/OFF switch on the rear panel to ON. The LEDs will light and
all segments will light temporarily as a check of the display.
2. After the diagnostics are complete, the Temperature Controller will dis-
play the unit identification screen (refer to Figure 6).
TEMPERATURE
CONTROLLER
FIGURE 6. UNIT IDENTIFICATION SCREEN
This screen will be displayed for a few seconds. The unit will automati-
cally progress to the RUN screen.
3. Press MENU once to begin the set up process.
Thermocouple
1. To select a thermocouple type, press the MENU key (refer to Figure 7).
2. The screen will display the last thermocouple selected. To chose an-
other thermocouple type, press the DOWN arrow key to move forward
or, if passing a desired selection, the UP arrow key to move backward.
Thermocouple selections include: K, J, E, B, T, S, R, and N.
3. Select the thermocouple type by pressing the MENU key. To ensure
proper operation, be sure that the correct thermocouple type is connected
at the thermocouple jack before running the controller.
THERMOCOUPLE
TYPE J
FIGURE 7. THERMOCOUPLE SELECTION SCREEN