PASCO Xplorer-GLX Users’ Guide - Manual (Page 37)

X p l o r e r G L X U s e r s ’ G u i d e 31
F4 Tables
From the Tables menu, you can select to display one, two, three, or four col-
umns.
24 If you increase the number of columns, new columns are added to the
right side (the GLX automatically selects data sources, if available, for new col-
umns). If you decrease the number of columns, they will be removed from the
right side (the data displayed in those columns disappears, but is not be perma-
nently deleted).
Tables with one, two, three, and four columns
Other options in the Tables menu are described below.
Show Time Select Show Time to add a column of time data in the left-most
position. 25 If there are four columns displayed when you select Show Time, the
fourth column will be removed and the other three columns will shift to the right
to make room for the time column on the left.
Date/Time To turn on this option, select it from the Tables menu. With the
option turned on, times displayed in the Table appear as the date and time of day
at which each data point was recorded. With the Date/Time option turned off,
time data appears as measured from the start of data collection.
The Date/Time format is set in the Settings screen. See page 85.
Lock Run Selection When Lock Run Selection is on (which it is by default),
all data columns will display the same run number, and changing the run number
F4
Tables Menu
24 To select an option from the Tables
menu
Keypad
1. Press
t o open the Tables menu.
2. Use the arrow keys to move the high-
light to the desired menu option and
press ;
or press the number on the
keypad corresponding to the desired
menu option.
Mouse
1. Click “Tables” at the bottom of the
screen to open the Tables menu.
2. Click the desired menu option.
F4
25 To show time in a column other than
the first one, select it from the data
source menu at the top of the desired
column. See “Data Source” on page 28
for more information.
Table with Date/Time option