PASCO SPARK Science Learning System User's Guide - Manual (Page 15)

S TARTING AN EXPERIMENT 7
M OVING ON FROM THE H OME SCREEN
Page-build screen: 1. Measurements. 2. Data display, image box, and
text box buttons. 3. Preview.
3. Touch the measurement (or measurements) that you would like to
show in the first data display.
Selected measurements are highlighted. Touch a measurement again to clear
a selection.
4. Touch one of the data display buttons for a graph, table, digits display,
or meter.
Data display buttons: graph, digits display, table, and meter.
If you select just one measurement, all data displays are available. If you select
two measurements, only the graph and table are available. If you select three
or more measurements, only the table is available.
The measurements and display that you have selected appear in the preview
section of the page-build screen.
5. Optionally, do any of the following:
• Repeat the steps above to select more measurements and add another
data display.
• Touch one of the image box buttons to add a large or small image box.
(After the page has been added to the SPARKlab, you can touch the
image box to select an image to display in the box.)
• Touch one of the text box buttons to add a large or small text box. (After
the page has been added to the SPARKlab, you can touch the text box
to enter text.)
• Touch the Undo button to remove an element from the preview.