Machine dimensions – Alliance Laundry Systems UF250PV Tilt User Manual
Page 17
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
15
F232102
Machine Dimensions
Refer to Figure 3 for dimensions of the 135 pound
capacity model. Refer to Figure 4, Figure 5, and
Figure 6 for dimensions of the 250 pound capacity
models.
Dimensional Clearances
Table 1 below shows recommended minimum
clearances on all sides of the washer-extractor.
Washer-extractors equipped with the tilt option require
a minimum overhead clearance, as well. Refer to
Figure 7 for the minimum overhead clearance for the
250 pound capacity model with tilt option.
NOTE: The dimensions shown here are for
planning purposes only. They are approximate and
subject to normal manufacturing tolerances. If
exact dimensions are required for construction
purposes, contact the distributor or manufacturer.
We reserve the right to make changes at any time
without notice.
Cabinet Freestanding
Recommended Minimum Clearances
135
250
Standard
Standard
Forward Tilt
Option
Two-Way
Tilt Option
Minimum rear clearance
24 in.
(610 mm)
24
in.
(610 mm)
36
in.
(914 mm)
36
in.
(914 mm)
Minimum clearance between washer-extractor
and wall
18
in.
(457 mm)
18
in.
(457 mm)
18
in.
(457 mm)
18
in.
(457 mm)
Minimum clearance between washer-extractors
(side)
18 in.
(457 mm)
18
in.
(457 mm)
18
in.
(457 mm)
18
in.
(457 mm)
Minimum front clearance
23 in.
(584 mm)
36
in.
(914 mm)
36
in.
(914 mm)
36
in.
(914 mm)
Minimum overhead clearance
60.5 in.
(1537 mm)
88
in.
(2235 mm)
108
in.
(2743 mm)
108
in.
(2743 mm)
Table 1