Alliance Laundry Systems UF250PV Tilt - Manual (Page 25)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
23 F232102
After the anchor bolts are installed and the concrete
has cured, proceed as follows:
1. Place the washer-extractor adjacent to the
foundation. Do not attempt to move it by pushing
on the sides. Always insert a pry bar or other
device under the bottom of the frame of the
washer-extractor to move it.
2. Remove the wood skid by unscrewing the
carriage bolts holding it to the bottom frame of
the washer-extractor.
3. Place the washer-extractor carefully over the
anchor bolts. Never attempt to lift the machine by
the door handle or by pushing on the cover
panels.
4. Raise and level the washer-extractor 1/2 inch off
the floor on three points, using spacers such as
nut fasteners.
5. Fill the spaces between the washer-extractor base
and floor with a good quality non-shrinking
machinery grout to ensure a stable installation.
Refer to Figure 11 for grouting the 135 pound
capacity model. Refer to Figure 12 for grouting
the 250 pound capacity model.
Figure 11
Figure 12
6. Remove the spacers carefully, allowing the
washer-extractor to settle into the wet grout.
7. Position the mounting bolt washers and locknuts
on the anchor bolts and fingertighten locknuts to
washer-extractor base.
8. After the grout is completely dry, tighten the
locknuts by even increments – one after the
other – until all are tightened evenly and the
washer-extractor is fastened securely to the floor.
9. Remove the four red transport brackets used to
secure the washer-extractor during shipping.
Refer to Figure 13.
NOTE: Check and retighten the locknuts after five
to ten days of operation and every month
thereafter.
R007I
1 Bolt Holes
2 Frame Rails
R077I
1
135
1
2
CFS216N
250
4 in.
(102 mm)
4 in.
(102 mm)
62 in.
(1575 mm)
71 in.
(1803 mm)
4 in.
(102 mm)
4 in.
(102 mm)