Alliance Laundry Systems UF250PV Tilt - Manual (Page 42)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
F232102 40
End of Day
1. Clean the AC drive box filter(s).
a. Snap off the external plastic cover which
contains the filter.
b. Remove the two foam filters from the cover.
c. Wash the filters with warm water and allow to
air dry. Filters can be vacuumed clean.
2. Clean motor cooling fan filter.
a. Snap off the external plastic cover which
contains the filter. Remove the foam filter
from the cover.
b. Wash the filter in a mild soap solution or
vacuum it clean.
3. Clean the door gasket of residual detergent and
all foreign matter.
4. Clean automatic supply dispenser and lid inside
and out with mild detergent. Rinse with clean
water.
5. Clean the washer’s top, front, and side panels
with mild detergent. Rinse with clean water.
6. Leave loading door open at the end of each day to
allow moisture to evaporate.
NOTE: Unload the washer-extractor promptly
after each completed cycle to prevent moisture
buildup. Leave loading door open at the end of each
completed cycle to allow moisture to evaporate.
Weekly
1. Check the machine for leaks.
a. Start an unloaded cycle to fill the machine.
b. Verify that door and door gasket do not leak.
c. Verify that the drain valve is operating. If
water does not leak out during the prewash
segment, drain valve is closed and functioning
properly.
Monthly
NOTE: Disconnect power to the machine at its
source before performing the monthly maintenance
procedures.
1. Each month OR after every 200 hours of
operation, lubricate bearings and seals. (Locate
the bearing lubrication decal behind the external
supply unit on the top right of the machine.)
a. Use a premium-grade lithium-based #2
grease. Never mix two types of grease, such
as petroleum and silicone.
b. Pump the grease gun slowly, permitting only
the following number of strokes:
● Bearing grease fitting, 2 strokes
● Seal grease fitting, 1 stroke
Do not pump the grease gun until grease
comes out of the bearing housing. This can
result in overlubrication, causing damageto
bearings and seals.
2. Clean the AC drive fins.
a. Remove the AC drive box cover.
b. Blow the fins clean using compressed air at a
pressure of 60 – 90 psi or by using canned
compressed air. Use care to avoid damaging
cooling fan or other components.
NOTE: No amount of visible foreign matter should
be allowed to accumulate on the fins or the finger
guard.