Teledyne 3060e - Ultra Trace oxygen analyzer - Manual (Page 29)

Teledyne Electronic Technologies
Analytical Instruments
3-3
Installation Installation Installation Installation Installation Ultra Ultra Ultra Ultra Ultra T T T T Trace Oxyg race Oxyg race Oxyg race Oxyg race Oxygen Anal en Anal en Anal en Anal en Analyz yz yz yz yzer er er er er
4. When adding electrolyte to the calibrator, do not overfill.
5. When hooking up electrical connections, do not connect the output
to the chassis.
6. Do not begin operating the analyzer until you have completed all of
the installation procedures.
Ultra Trace Sensor Installation
The analyzer is usually shipped with the sensor installed. If you need to install
or replace the sensor assembly before using the analyzer, use the procedure
below.
1. Prepare the analyzer casing for the sensor. Place four of the short
bolts in the holes on the side of the sensor and four of the long bolts
in the holes at the bottom of the sensor and bring the sensor between
the top and side stainless steel plates (see Figure 3-1). Leave all
eight bolts loose until Step 3.
Figure 3-1. Ultra Trace Sensor Bolt Installation
SIDE BO LTS
BASE BO LTS
O N
POWER
CONTRO L MODU LE
PPB OXYG
EN
PPM O XYGEN
TELEDYN E ANALYTIC AL INSTR UMENTS