Teledyne LXT-280 - Manual (Page 15)

Dissolved Oxygen Transmitter Installation
Teledyne Analytical Instruments 5
Installation
Installation of the LXT-280 Transmitter involves:
• Unpacking the instrument
• Mounting
• Making Electrical Connections
• Configuring the Instrument
• Calibration
2.1 Unpacking the Instrument
The LXT-280 Transmitter has been carefully packaged to protect it
from damage during shipment and dry storage. Upon receipt please
follow the procedure outlined below:
1. Before unpacking, inspect the condition of the shipping container
to verify proper handling by the carrier. If damage is noted, save
the shipping container as proof of mishandling for the carrier.
2. Check the contents of the shipping container with the items and
quantities shown on the packing list. Immediately report any
discrepancies to TI/TAI.
3. Save the original packing material until you are satisfied with the
contents. In the event the transmitter must be returned to the
factory, the packing material will allow you to properly ship it to
TI/TAI.
4. Familiarize yourself with the instrument before installation, and
follow proper installation and wiring procedures.
2.2 Mounting
The LXT-280 transmitter can be wall mounted or pipe mounted.
Installation drawings with dimensions are included at the back of this
manual. The power supply must be located in a non-hazardous area
while the transmitter and sensor can be installed in a hazardous