Teledyne LXT-280 - Manual (Page 16)

Installation LXT-280
Teledyne Analytical Instruments 6
environment as shown in Figure 2-1. For intrinsically safe installation,
an FM approved safety barrier must be installed between the power
supply/receiver and the transmitter as shown in Figure 2-2.
CAUTION: USE ONLY FM APPROVED SAFETY BARRIERS.
CONTACT TELEDYNE FOR A LIST OF FM
APPROVED INTRINSIC SAFETY BARRIERS FOR
YOUR APPLICATION.
If mounting hardware is ordered with the instrument, it has been
factory assembled and the LXT-280 is ready for mounting. A sunshade
should be considered during the selection of the mounting location
this prevents direct sunlight from creating an oven effect inside of the
enclosure.
Figure 2-1: Typical Installation for the LXT-280 Transmitter